Enable Portfast on Cisco switch port Switch>en Switch#conf t Switch(config)#int fa 0/24 (interface number) Switch(config-if)# spanning-tree portfast %Warning: portfast should only be enabled on ports connected to a single host. Connecting hubs, concentrators, switches, bridges, etc... to this interface when portfast is enabled, can cause temporary bridging loops. Use with CAUTION %Portfast has been configured on FastEthernet0/24 but will only have effect when the interface is in a non-trunking mode. Switch(config-if)#do wr Building configuration... [OK] Switch(config-if)#exit Portfast CLI command This notes are for everyone, who will find them helpful. Comments, questions, corrections are Welcome.
On this Blog You can read mini solutions from Tech World and not only...